Search results
Results from the WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks. The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface. Packet Tracer makes use of a drag and drop user ...
Website. www.wireshark.org. Wireshark is a free and open-source packet analyzer. It is used for network troubleshooting, analysis, software and communications protocol development, and education. Originally named Ethereal, the project was renamed Wireshark in May 2006 due to trademark issues. [5]
Products in this category are Cisco's range of routers, switches, wireless systems, security systems, WAN acceleration hardware, energy and building management systems and media aware network equipment. [1][2] IP video and phones, TelePresence, HealthPresence, unified communications, call center systems, enterprise social networks and Mobile ...
The message header is completed with the operation code for request (1) and reply (2). The payload of the packet consists of four addresses, the hardware and protocol address of the sender and receiver hosts. The principal packet structure of ARP packets is shown in the following table which illustrates the case of IPv4 networks running on ...
Enhanced Interior Gateway Routing Protocol. Enhanced Interior Gateway Routing Protocol (EIGRP) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers.
Often the route a packet needs to take through a network is not immediately available. In that case, the packet is queued and waits until a link is free. The physical link technologies of packet networks typically limit the size of packets to a certain maximum transmission unit (MTU). A longer message may be fragmented before it is transferred ...
traceroute. In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
Link State Packet (LSP) is a packet of information generated by a network router in a link state routing protocol that lists the router's neighbors. Link state packets can be further defined as special datagrams that determine the names of and the cost or distance to any neighboring routers and associated networks. They are used to efficiently ...