WOW.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Relative change - Wikipedia

    en.wikipedia.org/wiki/Relative_change

    A percentage change is a way to express a change in a variable. It represents the relative change between the old value and the new one. [6]For example, if a house is worth $100,000 today and the year after its value goes up to $110,000, the percentage change of its value can be expressed as = = %.

  3. Detection limit - Wikipedia

    en.wikipedia.org/wiki/Detection_limit

    Detection limit. The limit of detection (LOD or LoD) is the lowest signal, or the lowest corresponding quantity to be determined (or extracted) from the signal, that can be observed with a sufficient degree of confidence or statistical significance. However, the exact threshold (level of decision) used to decide when a signal significantly ...

  4. Calibration curve - Wikipedia

    en.wikipedia.org/wiki/Calibration_curve

    A calibration curve plot showing limit of detection (LOD), limit of quantification (LOQ), dynamic range, and limit of linearity (LOL).. In analytical chemistry, a calibration curve, also known as a standard curve, is a general method for determining the concentration of a substance in an unknown sample by comparing the unknown to a set of standard samples of known concentration. [1]

  5. Coefficient of variation - Wikipedia

    en.wikipedia.org/wiki/Coefficient_of_variation

    The coefficient of variation (CV) is defined as the ratio of the standard deviation to the mean , [1] It shows the extent of variability in relation to the mean of the population. The coefficient of variation should be computed only for data measured on scales that have a meaningful zero (ratio scale) and hence allow relative comparison of two ...

  6. Standard addition - Wikipedia

    en.wikipedia.org/wiki/Standard_addition

    The Standard addition method, often used in analytical chemistry, quantifies the analyte present in an unknown. This method is useful for analyzing complex samples where a matrix effect interferes with the analyte signal. In comparison to the calibration curve method, the standard addition method has the advantage of the matrices of the unknown ...

  7. Enantiomeric excess - Wikipedia

    en.wikipedia.org/wiki/Enantiomeric_excess

    Enantiomeric excess is defined as the absolute difference between the mole fraction of each enantiomer: [1] where. In practice, it is most often expressed as a percent enantiomeric excess. (1) The enantiomeric excess can be determined in another way if we know the amount of each enantiomer produced. If one knows the moles of each enantiomer ...

  8. Propagation of uncertainty - Wikipedia

    en.wikipedia.org/wiki/Propagation_of_uncertainty

    Propagation of uncertainty. In statistics, propagation of uncertainty (or propagation of error) is the effect of variables ' uncertainties (or errors, more specifically random errors) on the uncertainty of a function based on them. When the variables are the values of experimental measurements they have uncertainties due to measurement ...

  9. Gravimetric analysis - Wikipedia

    en.wikipedia.org/wiki/Gravimetric_analysis

    Gravimetric analysis describes a set of methods used in analytical chemistry for the quantitative determination of an analyte (the ion being analyzed) based on its mass. The principle of this type of analysis is that once an ion's mass has been determined as a unique compound, that known measurement can then be used to determine the same analyte's mass in a mixture, as long as the relative ...