Search results
Results from the WOW.Com Content Network
TDS = k e EC. where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 ...
Conductivity (electrolytic) Conductivity or specific conductance of an electrolyte solution is a measure of its ability to conduct electricity. The SI unit of conductivity is siemens per meter (S/m). Conductivity measurements are used routinely in many industrial and environmental applications as a fast, inexpensive and reliable way of ...
AFP – Active rire protection. AGA – American Gas Association. AGRU – acid gas removal unit. AGT – (1) agitator, used in drilling. AGT – (2) authorised gas tester (certified by OPITTO) AGT – (3) Azerbaijan – Georgia – Turkey (a region rich in oil related activity) [ 3 ] AHBDF – along hole (depth) below Derrick floor.
Wave-powered desalination. Electrodialysis (ED) is used to transport salt ions from one solution through ion-exchange membranes to another solution under the influence of an applied electric potential difference. This is done in a configuration called an electrodialysis cell. The cell consists of a feed (dilute) compartment and a concentrate ...
Galvanic corrosion. Corrosion of an iron nail wrapped in bright copper wire, showing cathodic protection of copper; a ferroxyl indicator solution shows colored chemical indications of two types of ions diffusing through a moist agar medium. Galvanic corrosion (also called bimetallic corrosion or dissimilar metal corrosion) is an electrochemical ...
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
An electrical conductivity meter (EC meter) measures the electrical conductivity in a solution. [1] It has multiple applications in research and engineering, with common usage in hydroponics, aquaculture, aquaponics, and freshwater systems to monitor the amount of nutrients, salts or impurities in the water.
Dielectric loss. In electrical engineering, dielectric loss quantifies a dielectric material 's inherent dissipation of electromagnetic energy (e.g. heat). [1] It can be parameterized in terms of either the loss angle δ or the corresponding loss tangent tan (δ). Both refer to the phasor in the complex plane whose real and imaginary parts are ...