WOW.com Web Search

  1. Ads

    related to: difference between wap and router bit

Search results

  1. Results from the WOW.Com Content Network
  2. Wi-Fi Protected Access - Wikipedia

    en.wikipedia.org/wiki/Wi-Fi_Protected_Access

    The flaw allows a remote attacker to recover the WPS PIN and, with it, the router's WPA/WPA2 password in a few hours. Users have been urged to turn off the WPS feature, although this may not be possible on some router models. Also, the PIN is written on a label on most Wi-Fi routers with WPS, which cannot be changed if compromised.

  3. Wireless access point - Wikipedia

    en.wikipedia.org/wiki/Wireless_access_point

    Wireless access point. [1] [2] In computer networking, a wireless access point, or more generally just access point ( AP ), is a networking hardware device that allows other Wi-Fi devices to connect to a wired network or wireless network. As a standalone device, the AP may have a wired connection to a switch or router, but, in a wireless router ...

  4. Wi-Fi Protected Setup - Wikipedia

    en.wikipedia.org/wiki/Wi-Fi_Protected_Setup

    The WPS push button (center, blue) on a wireless router showing the symbol defined by the Wi-Fi Alliance for this function. Wi-Fi Protected Setup ( WPS) originally, Wi-Fi Simple Config, is a network security standard to create a secure wireless home network . Created by Cisco and introduced in 2006, the point of the protocol is to allow home ...

  5. Service set (802.11 network) - Wikipedia

    en.wikipedia.org/wiki/Service_set_(802.11_network)

    A mesh basic service set ( MBSS) is a self-contained network of mesh stations that share a mesh profile, defined in 802.11s. [9] Each node may also be an access point hosting its own basic service set, for example using the mesh BSS to provide Internet access for local users. In such a system, the BSS created by the access point is distinct ...

  6. IEEE 802.11i-2004 - Wikipedia

    en.wikipedia.org/wiki/IEEE_802.11i-2004

    IEEE 802.11i-2004, or 802.11i for short, is an amendment to the original IEEE 802.11, implemented as Wi-Fi Protected Access II (WPA2). The draft standard was ratified on 24 June 2004. This standard specifies security mechanisms for wireless networks, replacing the short Authentication and privacy clause of the original standard with a detailed ...

  7. Wired Equivalent Privacy - Wikipedia

    en.wikipedia.org/wiki/Wired_Equivalent_Privacy

    152-bit and 256-bit WEP systems are available from some vendors. As with the other WEP variants, 24 bits of that is for the IV, leaving 128 or 232 bits for actual protection. These 128 or 232 bits are typically entered as 32 or 58 hexadecimal characters (4 bits × 32 + 24-bit IV = 152-bit WEP key, 4 bits × 58 + 24-bit IV = 256-bit WEP key).

  8. Wi-Fi - Wikipedia

    en.wikipedia.org/wiki/Wi-Fi

    v. t. e. Wi-Fi ( / ˈwaɪfaɪ /) [1] [a] is a family of wireless network protocols based on the IEEE 802.11 family of standards, which are commonly used for local area networking of devices and Internet access, allowing nearby digital devices to exchange data by radio waves. These are the most widely used computer networks, used globally in ...

  9. Comparison of wireless data standards - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_wireless...

    Typical 2G standards include GSM and IS-95 with extensions via GPRS, EDGE and 1xRTT, providing Internet access to users of originally voice centric 2G networks. Both EDGE and 1xRTT are 3G standards, as defined by the ITU, but are usually marketed as 2.9G due to their comparatively low speeds and high delays when compared to true 3G technologies.

  1. Ads

    related to: difference between wap and router bit