Search results
Results from the WOW.Com Content Network
Circuit breaker is a design pattern used in software development. It is used to detect failures and encapsulates the logic of preventing a failure from constantly recurring, during maintenance, temporary external system failure or unexpected system difficulties.
The design balanced objectives such as payload mass, landing capabilities, and reliability. The initial design showed the ship with six Raptor engines (two sea-level, four vacuum) down from nine in the previous ITS design. [9] By September 2017, Raptors had been test-fired for a combined total of 20 minutes across 42 test cycles.
A translinear circuit is a circuit that carries out its function using the translinear principle. These are current-mode circuits that can be made using transistors that obey an exponential current-voltage characteristic—this includes bipolar junction transistors (BJTs) and CMOS transistors in weak inversion.
This process is a part of a logic synthesis applied in digital electronics and integrated circuit design. Generally, the circuit is constrained to a minimum chip area meeting a predefined response delay. The goal of logic optimization of a given circuit is to obtain the smallest logic circuit that evaluates to the same values as the original ...
Since digital circuits are made from analog components, digital circuits calculate more slowly than low-precision analog circuits that use a similar amount of space and power. However, the digital circuit will calculate more repeatably, because of its high noise immunity.
To design a log amplifier circuit, high performance op-amps like LM1458, LM771, LM714 are commonly used and a compensated log amplifier may include more than one. In some situations, especially in RF domain, monolithic log amplifiers are also used to reduce number of components and space used, as well improve bandwidth and noise performance.
Transistor–transistor logic (TTL) is a logic family built from bipolar junction transistors.Its name signifies that transistors perform both the logic function (the first "transistor") and the amplifying function (the second "transistor"), as opposed to earlier resistor–transistor logic (RTL) and diode–transistor logic (DTL).
Quantum algorithms are usually described, in the commonly used circuit model of quantum computation, by a quantum circuit that acts on some input qubits and terminates with a measurement. A quantum circuit consists of simple quantum gates, each of which acts on some finite number of qubits.