WOW.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Help:Convert - Wikipedia

   en.wikipedia.org/wiki/Help:Convert

   H:CON. Template { { convert }} is used to convert a value from one unit of measurement to another. This page provides an overview of the options available when using the template. See the documentation at Template:Convert for further details. Help:Convert units • Simplified list of some commonly used units.

3. British standard ordnance weights and measurements - Wikipedia

   en.wikipedia.org/wiki/British_standard_ordnance...

   The British standard ordnance weights and measurements for the artillery were established by the Master General of Ordnance in 1764, and these were not altered until 1919, [citation needed] when the metric system was additionally introduced. This system has largely been replaced by defining the weapon in terms of the measurement of the calibre ...

4. N scale - Wikipedia

   en.wikipedia.org/wiki/N_scale

   N scale. N scale is a popular model railway scale. [1] Depending upon the manufacturer (or country), the scale ranges from 1:148 to 1:160. Effectively the scale is 1:159, 9 mm to 1,435 mm ( 4 ft in ), which is the width of standard gauge railway. However the scale may vary to simulate wide or narrow gauge rail.

5. List of battery sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_battery_sizes

   3LR12 (4.5-volt), D, C, AA, AAA, AAAA (1.5-volt), A23 (12-volt), PP3 (9-volt), CR2032 (3-volt), and LR44 (1.5-volt) batteries. This is a list of the sizes, shapes, and general characteristics of some common primary and secondary battery types in household, automotive and light industrial use. The complete nomenclature for a battery specifies ...

6. Imperial units - Wikipedia

   en.wikipedia.org/wiki/Imperial_units

   Imperial units. The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road) The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 ( 5 Geo. 4. c.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.