Search results
Results from the WOW.Com Content Network
Confusingly, sometimes when people refer to wMAPE they are talking about a different model in which the numerator and denominator of the wMAPE formula above are weighted again by another set of custom weights .
(200% for the first formula and 100% for the second formula). Provided the data are strictly positive, a better measure of relative accuracy can be obtained based on the log of the accuracy ratio: log( F t / A t ) This measure is easier to analyse statistically, and has valuable symmetry and unbiasedness properties.
The relative change is independent of the unit of measurement employed; for example, the relative change from 2 to 1 m is −50%, the same as for 200 to 100 cm.The relative change is not defined if the reference value (v ref) is zero, and gives negative values for positive increases if v ref is negative, hence it is not usually defined for negative reference values either.
Because actual rather than absolute values of the forecast errors are used in the formula, positive and negative forecast errors can offset each other; as a result, the formula can be used as a measure of the bias in the forecasts. A disadvantage of this measure is that it is undefined whenever a single actual value is zero. See also
EVM is generally expressed in percent by multiplying the ratio by 100. [1] The ideal signal amplitude reference can either be the maximum ideal signal amplitude of the constellation, or it can be the root mean square (RMS) average amplitude of all possible ideal signal amplitude values in the constellation.
Definition and basic properties. The MSE either assesses the quality of a predictor (i.e., a function mapping arbitrary inputs to a sample of values of some random variable), or of an estimator (i.e., a mathematical function mapping a sample of data to an estimate of a parameter of the population from which the data is sampled).
where represents the standard deviation of the function , represents the standard deviation of , represents the standard deviation of , and so forth.. It is important to note that this formula is based on the linear characteristics of the gradient of and therefore it is a good estimation for the standard deviation of as long as ,,, … are small enough.
In signal processing, control theory, electronics, and mathematics, overshoot is the occurrence of a signal or function exceeding its target. Undershoot is the same phenomenon in the opposite direction. It arises especially in the step response of bandlimited systems such as low-pass filters. It is often followed by ringing, and at times ...