Search results
Results from the WOW.Com Content Network
Four-position, four-contact (4P4C) plug, used for connecting a telephone handset and base. Six-position, six-contact (6P6C) jack, which could be wired as RJ11, RJ14, or RJ25. A registered jack ( RJ) is a standardized telecommunication network interface for connecting voice and data equipment to a computer service provided by a local exchange ...
The GG45 and ARJ45 connectors operate in the frequency band between 600 MHz and 5 GHz with shielded twisted pair and twinax cables. To reduce crosstalk, two of the four pairs have been moved so that each pair occupies one corner. GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into ...
Punch down tool. A punch down tool with interchangeable blades. A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks, patch panels ...
Power over Ethernet. In this configuration, an Ethernet connection includes Power over Ethernet (PoE) (gray cable looping below), and a PoE splitter provides a separate data cable (gray, looping above) and power cable (black, also looping above) for a wireless access point (WAP). The splitter is the silver and black box in the middle between ...
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers) or two switches to each other. By contrast, straight through patch cables are used to connect devices of ...
A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router) are connected with patch cords. Patch cords are usually produced in many different ...
Autonegotiation. Autonegotiation is a signaling mechanism and procedure used by Ethernet over twisted pair by which two connected devices choose common transmission parameters, such as speed, duplex mode, and flow control.
This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets. Modular connectors were originally ...