Search results
Results from the WOW.Com Content Network
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. The French units roughly correspond to the outer circumference of the catheter (see table below).
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside diameter).
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length.
The QF 3.7-inch AA was Britain's primary heavy anti-aircraft gun during World War II. It was roughly the equivalent of the German Flak 8.8 cm and American 90 mm, but with a slightly larger calibre of 3.7 inches, approximately 94 mm. Production began in 1937 and it was used throughout World War II in all theatres except the Eastern Front.
7.02 mm: Model railways (0) Exact O scale of 7 mm = 1 foot. 1:43: 7.088 mm: Die-cast cars: Still the most popular scale for die-cast cars worldwide, metric or otherwise. It originates from British O scale. 1:40: 0.3 in: 7.620 mm The very early models of the British Coronation Coach and a few other horse-drawn wagons were made in this scale.
As well as 1 ⁄ 4 in (6.4 mm) tape, studio and multitrack machines use tape widths of 1 ⁄ 2, 1, and 2 inches (12.7, 25.4, and 50.8 mm), and at least one 3 inches (76.2 mm) [citation needed] machine was available for a time. There is also a 35 mm width, but this variety is more similar to the motion picture stock of the same width. It is ...
3-inch (76 mm) 375 μm 1972 29 4-inch (100 mm) 525 μm 1976 10 grams : 56 4.9 inch (125 mm) 625 μm 1981 95 150 mm (5.9 inch, usually referred to as "6 inch") 675 μm 1983 144 200 mm (7.9 inch, usually referred to as "8 inch") 725 μm. 1992 53 grams : 269 300 mm (11.8 inch, usually referred to as "12 inch") 775 μm 1999 125 grams: 640 450 mm ...
In the normal series, the long edge is the length of the short edge plus 2 inches (10 in or less) or 3 inches (11 in and above). The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice ...