Search results
Results from the WOW.Com Content Network
The WPS push button (center, blue) on a wireless router showing the symbol defined by the Wi-Fi Alliance for this function. Wi-Fi Protected Setup (WPS) originally, Wi-Fi Simple Config, is a network security standard to create a secure wireless home network. Created by Cisco and introduced in 2006, the purpose of the protocol is to allow home ...
The flaw allows a remote attacker to recover the WPS PIN and, with it, the router's WPA/WPA2 password in a few hours. [48] Users have been urged to turn off the WPS feature, [49] although this may not be possible on some router models. Also, the PIN is written on a label on most Wi-Fi routers with WPS, which cannot be changed if compromised.
Multiprotocol Label Switching. Multiprotocol Label Switching (MPLS) is a routing technique in telecommunications networks that directs data from one node to the next based on labels rather than network addresses. [1] Whereas network addresses identify endpoints, the labels identify established paths between endpoints.
Label Information Base (LIB) is the software table maintained by IP/ MPLS capable routers to store the details of port and the corresponding MPLS router label to be popped/pushed on incoming/outgoing MPLS packets. Entries are populated from label-distribution protocols. LDP is a protocol that automatically generates and exchanges labels between ...
Link-state advertisement. The link-state advertisement (LSA) is a basic communication means of the OSPF routing protocol for the Internet Protocol (IP). It communicates the router's local routing topology to all other local routers in the same OSPF area. OSPF is designed for scalability, so some LSAs are not flooded out on all interfaces, but ...
Label Distribution Protocol (LDP) is a protocol in which routers capable of Multiprotocol Label Switching (MPLS) exchange label mapping information. Two routers with an established session are called LDP peers and the exchange of information is bi-directional. LDP is used to build and maintain label-switched path (LSP) databases that are used ...
An ingress router is a label switch router that is a starting point (source) for a given label-switched path (LSP). An ingress router may be an egress router or an intermediate router for any other LSP (s). Hence the role of ingress and egress routers is LSP specific. Usually, the MPLS label is attached with an IP packet at the ingress router ...
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers) or two switches to each other. By contrast, straight through patch cables are used to connect devices of ...