Search results
Results from the WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available for virtually all operating systems that have networking capability, including most embedded network administration software. Ping measures the round-trip time for messages sent from the ...
Round-trip delay. In telecommunications, round-trip delay (RTD) or round-trip time (RTT) is the amount of time it takes for a signal to be sent plus the amount of time it takes for acknowledgement of that signal having been received. This time delay includes propagation times for the paths between the two communication endpoints. [1]
traceroute. In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
The ICMP header starts after the IPv4 header and is identified by its protocol number, 1. [4] All ICMP packets have an eight-byte header and variable-sized data section. The first four bytes of the header have fixed format, while the last four bytes depend on the type and code of the ICMP packet.
Paping (pronounced pah ping) is a computer network administration utility used to test the reachability of a host on an Internet Protocol (TCP/IP) network and to measure the time it takes to connect to a specified port. The name is a play on the word ping, another computer network administration utility. Because ICMP can be used to identify the ...
A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file. The throughput is then calculated by dividing the file size by the time to get the throughput in megabits, kilobits, or bits per second.
[citation needed] The lower one's ping is, the lower the latency is and the less lag the player will experience. High ping and low ping are commonly used terms in online gaming, where high ping refers to a ping that causes a severe amount of lag; while any level of ping may cause lag, severe lag is usually indicated by a ping of over 100 ms. [2]
PathPing. The PathPing command is a command-line network utility included in Windows NT operating systems since Windows 2000 that combines the functionality of ping with that of tracert. [1] It is used to locate spots that have network latency and network loss. [2][3]